Inconsistent filament diameter

In this article is described what to do when Devovision presents a inconsistent filament diameter.

Error Messages

During the extrusion it might be possible an error message appears on the display of the Filament Maker. In this article is explained what could have caused the error messages and how to prevent it from happening.

Nozzle build-up

In this article is described what nozzle build-up is and how it can be prevented.

Bumps or particles in filament

bumps or small particles are sometimes visible on the produced filament. In this article is described what could cause this bumps and how you can fix it.

Output too low or thin

In this article is described what to do when the output of material is too low.

Waving/Curling filament

In this article is described what could cause a polymer to start waving between the nozzle and the IR sensor. This article will also cover the possible solutions.

Polymer degradation

In this article is described what could cause a polymer to degrade while being processed on the Filament Maker.

Abnormal smoke production

In this article is described what could cause abnormal smoke production and how you can solve this issue.

Output is too liquid

In this article is described what could cause the output of material to be too liquid and how to solve this.

Logging data with Arduino

In this article is explained how Arduino can be used as an alternative to log your extrusion data.