Filament Maker X10 – Network Troubleshooting
Use the checks below if you cannot access one of the Filament Maker X10 network interfaces.
Check the Ethernet Connection
Make sure:
- The Ethernet cable is securely connected.
- The cable is connected to the correct network.
- The Filament Maker X10 is powered on.
Check the IP Address
Verify the IP address shown in the X10's network settings.
Make sure the address entered into the browser matches the current machine IP address.
Check the Network
If the X10 is connected to a LAN:
- Confirm the PC is connected to the same network.
- Check whether your organization's firewall blocks the required ports.
- Contact your network administrator if required.
Check the Machine
Restarting the Filament Maker X10 may resolve temporary network or software issues.
⚠️ Important: Do not repeatedly disconnect the machine from mains power as a method of restarting it. Use the normal shutdown procedure whenever possible.
Network Interfaces
Verify that you are using the correct port:
:80— Machine interface:8000— Filament Sensor feed:8086— InfluxDB dashboard
Next Step
If the network connection is working, return to the relevant interface:
Filament Maker X10 – Data Dashboard
Filament Maker X10 – Remote Monitoring and Control
Filament Maker X10 – Filament Sensor Data and Camera Feed