Filament Maker TWO
The Filament Maker TWO user manual and additional helpful articles.
Getting started
Maintenance and configuration adjustments
- Maintenance schedule of the Filament Maker TWO
- Hopper sensor 3D model for the Filament Maker TWO
- Filament Maker TWO sensor cleaning
- Filament Maker TWO screw removal and cleaning
- Filament Maker TWO sensor calibration
- Filament Maker TWO nozzle cover change
- Filament Maker TWO nozzle change
- Filament Maker TWO puller wheel change
Firmware
Software and Data management (InfluxDB)
Troubleshooting
- Error messages of the Filament Maker TWO
- ER21 - Screw load exceeds maximum force
- ER03 - Heater failed to reach target temperature
- ER04 - Temperatures reached without active extrusion.
- ER01 - Failed to read thermocouple
- ER02 - Heater temperature too high
- ER10 - Failed to detect the hopper
- ER11 - Hopper nearly empty
- ER12 - Hopper empty, final warning
- ER13 - Hopper empty, system shutdown
- ER20 - Screw load is unusually high
- ER25 - Fault pin active (over-current detection)
- Touchscreen does not respond (and other display issues)