Support home

Back to home

Support home

Filament Maker TWO

Filament Maker TWO

The Filament Maker TWO user manual and additional helpful articles.

Getting started

Filament Maker TWO Initial extrusion

Filament Maker TWO user manual

Boxing the Filament Maker TWO

Maintenance and configuration adjustments

Maintenance schedule of the Filament Maker TWO

Filament Maker TWO screw removal and cleaning

Filament Maker TWO sensor calibration

Filament Maker TWO nozzle cover change

Filament Maker TWO nozzle change

Filament Maker TWO puller wheel change

See more

Firmware

Firmware and user interface overview of the Filament Maker TWO

Firmware update for the Filament Maker TWO

Firmware release notes for the Filament Maker TWO

Software and Data management (InfluxDB)

Accessibility and safety

Set up a LAN connection and connect to the Filament Maker TWO

How to show the data shared by the Filament Maker TWO

Interface overview of InfluxDB

Dashboard view for InfluxDB

Dashboards for InfluxDB

How to download CSV data from InfluxDB

Diameter Monitoring in InfluxDB

See more

Troubleshooting

Error messages of the Filament Maker TWO

ER01 - Failed to read thermocouple

ER02 - Heater temperature too high

ER10 - Failed to detect the hopper

ER11 - Hopper nearly empty

ER12 - Hopper empty, final warning

ER13 - Hopper empty, system shutdown

ER20 - Screw load is unusually high

ER25 - Fault pin active (over-current detection)

Touchscreen does not respond (and other display issues)

See more

Health, safety and warranty

Filament Maker TWO - Declaration of conformity