Filament Maker X10 – Maintenance Schedule

Regular maintenance is essential to keep the Filament Maker X10 operating safely and consistently while maintaining good filament extrusion quality.

Maintenance Schedule

Follow the recommended maintenance schedule below.

Frequency	Maintenance	Purpose
Every extrusion or when necessary	Purge the extrusion system	Remove polymer residue and keep the extrusion system clean.
Every extrusion or when necessary	Clean the extrusion area	Remove polymer residue and dust.
Every 3 months / 10 experiments	Check the nozzle	Inspect for residue and replace when worn.
Every 3 months / 10 experiments	Check the nozzle cover	Inspect for heat damage and replace when necessary.
Every 3 months / 10 experiments	Check the hopper	Deep clean the hopper and vibration feeder when required.
Every 3 months / 10 experiments	Check the conveyor belt	Inspect and clean the conveyor belt and puller surface when required.
Every year / 100 experiments	Calibrate the Filament Sensor	Verify sensor measurement accuracy.
Every year / 100 experiments	Lubricate the positioner	Clean and lubricate the lead screw and guiding axle.

The maintenance schedule is a guideline. Perform maintenance more frequently if you notice unexpected wear, contamination, or changes in machine performance.

Next Step

For maintenance after an extrusion: Filament Maker X10 – Purging the Extrusion System

Flow

Maintenance Schedule
↓
Purging the Extrusion System
↓
Cleaning the Extrusion Area
↓
Inspecting and Replacing the Nozzle
↓
Replacing the Nozzle Cover
↓
Filament Sensor Calibration