Skip to content
Contact us!
  • There are no suggestions because the search field is empty.

Filament Maker X10 – Update the Firmware

Keeping the Filament Maker X10 firmware up to date helps maintain machine safety, privacy, security, and overall system performance.

The firmware can be updated in two ways:

  • Via Ethernet – the easiest and recommended method when an active internet connection is available.
  • Via USB – an offline alternative when the machine cannot access the internet.

⚠️ Important: Always use the latest firmware provided by 3devo and follow the update procedure carefully.

Update via Ethernet

Updating through Ethernet is the easiest way to keep the Filament Maker X10 firmware current.

The Filament Maker X10 must be connected to a network router that provides an active internet connection.

The machine automatically checks for available firmware updates whenever it restarts. You can also manually check for an update through the touchscreen.

Step 1 – Open Settings

From the Filament Maker X10 main menu, select Settings.

Step 2 – Open Firmware

Select Firmware.

Step 3 – Check for Updates

Select Check Latest Firmware Version.

Step 4 – Install the Update

Wait while the machine searches for the latest firmware.

If an update is available, the machine will download and install the firmware.

💡 Tip: Allow the update to complete before interrupting or powering down the machine.

Update via USB

If the Filament Maker X10 does not have access to an active internet connection, the firmware can be updated offline using a USB drive.

Step 1 – Download the Latest Firmware

Visit the 3devo firmware page and follow the instructions to download the latest firmware file to your computer:

Firmware update

Step 2 – Prepare the USB Drive

Copy the firmware file directly into the root folder of a USB drive.

Do not place the firmware file inside another folder.

Step 3 – Insert the USB Drive

Insert the USB drive into the USB port located in the extrusion area of the Filament Maker X10.

Step 4 – Install the Firmware

The machine will detect the firmware file on the USB drive and install the update.

⚠️ Important: Do not remove the USB drive or interrupt the machine while the firmware update is being installed.

Firmware Update Checklist

Ethernet Update

  • Connect the X10 to a network with an active internet connection.
  • Open Settings.
  • Select Firmware.
  • Select Check Latest Firmware Version.
  • Allow the machine to find and install the update.
  • Do not interrupt the update process.

USB Update

  • Download the latest firmware from 3devo.
  • Copy the firmware file to the USB drive's root folder.
  • Insert the USB drive into the USB port in the extrusion area.
  • Allow the X10 to detect and install the update.
  • Do not interrupt the update process.
Software and Firmware Disclaimer

Software provided with the Filament Maker X10 is intended only for use with the device and is subject to the applicable software license agreement.

3devo reserves the right to update the machine's software and firmware without prior notice.