Filament Maker ONE
Filament Maker ONE documentation, troubleshooting and helpful resources.
Getting started
Extrusion Essentials
Purging
Maintenance
- Filament Maker maintenance guide
- Filament Maker PLA Quality Control
- Replace the nozzle of the Filament Maker
- Removing the Filament Maker top hood for maintenance procedures
- Filament Maker firmware updates
- Firmware release notes for the Filament Maker
- Replace the Puller Wheel of the Filament Maker
- Clean the Filament Maker optical sensor glass
- Removing the Back Panel
- Heater swap guide
- Replace the thermocouple of the Filament Maker
- Cleaning the extrusion area of the Filament Maker
Accessories
Health and safety
Troubleshooting
- The Filament Maker extruder screw is NOT rotating
- The Filament Maker heater 1 (H1) takes more time to heat up
- The Filament Maker produces abnormal loud squeaky noise
- The Filament Maker extruder screw is rotating, but NO material output
- "Extruder motor or encoder error"
- The Filament Maker has no or low output
- Filament Maker Error Messages
- "Failure reading a thermocouple"
- "Extruder motor thermistor is not connected"
- "Motor current too high"
- Permanent Black Screen
- Filament Sensor Shows "0" (zero)
- Interface Knob Does Not React
- DevoStick: How to solve Feeding Issues
- Understanding pressure, and tips to avoid clogging!
- How to insulate the nozzle (optional)